Touch LCD Shield Case

This is the official 3D printable Touch LCD case for your OpenMV Cam!The case perfectly fits around your OpenMV Cam while exposing all the ports and features light pipes for the board LEDs. We have a case cover that exposes the GPIO ports and one that does not. Best of all, you can press the buttons on your OpenMV Cam through the case even features a battery compartment where you can fit a small 400mA lipo Battery from SparkFun () under the camera. You can then power your OpenMV Cam from the battery, and the case comes with a cover to put over the exposed extra mounting hardware is required to use the case. You just need to make sure the pin headers are soldered on your OpenMV Cam. The lid snaps on, and we have a go-pro y, you can secure your OpenMV Cam in the case more tightly you use M2.5 nuts with M2.5 6mm screws to attach the camera to the case. However, these are not necessarily required thanks to the smart case design.